Electric Wagon Instructions
1) To charge the wagon make sure the wagon is in the off position (key switch) then plug the XLR PLUG of the charger first on the control panel of the wagon then plug it in the wall socket. When it is charging the light will glow RED and when it is fully charged it will glow GREEN.
Always disconnect the plugs from the connector itself NOT FROM THE WIRE.
You shouldn't need to charge it for more than 24 hrs. Try not to let the batteries go completely dead.
2) There is a switch that makes the wagon go forward in the UP position and in the LOWER position is reverse
On the MIDDLE position is neutral so you can move the wagon around easily.
3) On the handle you have a brake and the speed controller. There is also a display with three LEDS that indicates...
(RED) the power is on.
(GREEN) is full charge.
(YELLOW) battery is low needs to be charged.
4) Always remember to REMOVE THE KEY SO THE KIDS DON'T TAKE OF WITH THE WAGON. You can also put it in neutral for extra safety.
5) Try to keep the handle from hitting the ground and out of the sand there is a magnet in the speed controller and it may attract ferrite from the sand and may cause the controller to not function correctly. It can be cleaned with compressed air.
6) The chain drive is a standard bike chain that can be cleaned with the same stuff that you use for bicycles.
Don't use WD40, sand sticks to the chain and makes it worse. You can use chain wax (whitelightning) brand to lube the chain.
Local bike shops have the supplies.
Any questions just give me a call.